Just putting the finishing touches to my R33 GTST for 2007 Ran the car last year with the RB25 & standard gearbox & best we could do was 9.93 @141. We broke god knows how many drive shafts keeping the IRS & then thought sod it - we need to make a decision in terms of what to do for 2007.
RWD Skyline เเปลก ๆ นะเอิ๊ก ๆ เดียวถ้ายังไง รอชมคลิบคับ . . อยากเห็นมานานเเล้ว เจ้า Skyline Drag Rwd ตอนนี้สมใจเเล้ว จะติดตามเจ้าคันนี้ต่อไป ถ้ามีข่าวความคืบหน้ายังไงเดียวมาบอกกล่าวกัน . .
Up Spac RB26 bored to 2.8 HKS pistons, HKS Rods,HKS Billet Crank, HKS T51 SPL BB Turbo, HKS Fuel Rail, 1600 cc Injectors, Jun Cams, Jun Plenum, One off head gasket & rings, Dry Sump, Ported & polished Head & loads of other bits & bobs.
PROJECT GTST " Specification 2007... 2007 Spec Revealed so far.. Engine RB26 bored to 2.8 HKS pistons HKS billet crank shaft HKS Fuel Rail HKS T51 SPL BB Turbo HKS Manifold & Wastegate HKS Drag Intercooler HKS F CON V PRO ECU JUN Plenum JUN Cams One Off GT ART head gasket One Off GT ART ringset GT ART Ported & Polished drag cylinder head GT ART Hard Pipe Kit Greddy Oil Cooler Mocal Oil Cooler Bosch Fuel Pump CHASSIS (Andy Robinson Race Cars) Full Pro Mod Cage legal to 7.5sec <<<<<<<<<< 5 5 5 Jerico 5 speed gearbox with air shifter Titanium bell housing Mark Williams aluminium propshaft Strange drag suspension all round Strange brake discs & calipers all round One Off Andy Robinson Drag axle Stroud parachute Andy Robinson Drag Spoiler arrangement Video http://www.dropshots.com/day.php?userid=328828&cdate=20070715
first run 9.1 @ 161 2nd run 8.7 @ 144 3rd run 8.5 @ 161 http://video.google.co.uk/videoplay?...64959&hl=en-GB http://www.youtube.com/watch?v=lB2qsj4Tzm0 คลิปไม่ชัดเท่าไรนะ . .
Clip มาเเล้ว . . http://www.youtube.com/watch?v=r-DIbQQ67JA http://www.youtube.com/watch?v=yZOukvRClXM
Project GTST Well finally we have started running again & great to have a full year ahead Spent the whole day doing nothing but working on clutch set up & launches & really started to pay off towards the end of the day with the last 3 60 foots being 1.26 then 1.18 then 1.17 which is great (best last year after the car was finished in august was 1.29). Still think we can get that down further to around 1.02 - 1.05 with more work/knowledge & further runs & more datalogging info. Determined to work slowly but methoidically this year ticking a box off at a time rather than trying to rush things. wont even look at turning the power up until we start getting consistent launches first. piccie below from the day & start running in anger in 2 weeks - cant wait
อัฟเดท ล่าสุด 7sec 3 runs in total & all 7's 1st 7.93 @ 171 2nd 7.78 @ 172 3rd 7.75 @ 175 After all the hard work & learning this year i'm over the moon First 2 runs were at 2 bar boost & the third at 2.2, 3rd would have been quicker if i had changed gear better. We run again next week in our last official competition of the year, we have more boost to go yet & could connect nos up (but not so sure we will until next year) so may get those times down a bit further still.